SCADAPack I/O Configuration in Telepace Studio
Key Takeaway
How to configure digital, analog, and pulse I/O on SCADAPack RTUs in Telepace Studio — module assignment, input types, and address mapping.
Quick Answer
SCADAPack I/O is configured in the Telepace Studio hardware configuration tab. Assign onboard and expansion I/O modules, select input types per channel (4-20mA, 0-10V), and verify address mappings in the I/O map.
Onboard I/O (SCADAPack 350)
- 8 analog inputs (configurable 4-20mA or 0-10V per channel)
- 4 analog outputs (4-20mA)
- 16 digital inputs (wet or dry contact)
- 8 digital outputs (relay)
- 4 pulse/accumulator inputs (flow meter counting)
Configuration Steps
- Open Hardware Configuration in the project tree
- Select the base unit model
- Add expansion modules (if installed)
- Configure each analog input channel type
- Set digital input filtering and output type
- Verify the I/O address map
Expansion Modules
SCADAPack I/O expansion modules add analog, digital, and communication channels. Modules connect to the base unit via the expansion bus and are configured in the Telepace Studio hardware configuration.
Need help with scada & programming?
Texas-based licensed engineers — get a free, no-obligation assessment.
Frequently Asked Questions
8 analog inputs, 4 analog outputs, 16 digital inputs, and 8 digital outputs onboard, expandable with expansion modules.
4-20mA current loop and 0-10VDC voltage inputs, configurable per channel. RTD and thermocouple via specialized expansion modules.
Still have questions about your setup? Talk to an engineer or call (210) 405-4248.