Telepace Studio Installation and Setup
Key Takeaway
Step-by-step guide to installing Telepace Studio, creating a new SCADAPack project, and connecting to a SCADAPack RTU via USB, serial, or Ethernet.
Quick Answer
Telepace Studio is the programming environment for SCADAPack RTUs. Install it on Windows, create a project matching your SCADAPack model and firmware, and connect via USB, serial, or Ethernet (TCP port 20000) to go online.
System Requirements
- Windows 10 or Windows 11
- .NET Framework 4.6.2+
- Telepace Studio license from Schneider Electric
Installation
- Download from Schneider Electric's software portal
- Run installer as Administrator
- Activate the license (hardware key or software activation)
Creating a Project
- Launch Telepace Studio → New Project
- Select the SCADAPack model (e.g., SCADAPack 350)
- Select the firmware version matching the physical unit
- Configure the base I/O and expansion modules
Connecting
- USB — Install the USB driver (included), select COM port
- Ethernet — Enter the SCADAPack IP address, TCP port 20000
- Serial — RS-232 direct connection, configure baud rate
Need help with scada & programming?
Texas-based licensed engineers — get a free, no-obligation assessment.
Frequently Asked Questions
Telepace Studio requires a license from Schneider Electric. A limited offline mode may be available, but going online requires a valid license.
TCP port 20000 by default for Ethernet connections to SCADAPack RTUs.
Still have questions about your setup? Talk to an engineer or call (210) 405-4248.